An Aston Martin DB12 wrapped in red is a full color change over the original paint. Start with the finish, then pick a film, then decide on full coverage or a partial wrap. The first generation comes as a convertible or coupe with two long side doors. Each door is one large piece of film, which matters for installation.
A wrap covers the factory paint and leaves no visible seams on large panels. Panel edges and door jambs are the only places where film lines appear. On the DB12, the two long doors are covered with single sheets of film. The paint stays intact under the film.
Red wrap film is removable from the Aston Martin DB12 without leaving adhesive on the paint. Use a hand wash with a soft mitt and avoid pressure washers at edges. This keeps the film clean without lifting the removable layer.