Choosing a Vantage wrapped in camo or patterned film starts with the finish group, then the film line. On this car a full color change needs about 48 ft (14.5 m) of 60-inch (1.52 m) cast film for the newest convertible to 49 ft (15 m) for the coupe. The two long side doors are each covered with one large piece of film. A partial wrap keeps the job smaller and leaves more factory paint visible.
Factory paint under a wrap stays protected, and the film hides minor chips and scratches on the surface. Seams on the Vantage are planned to sit at body lines, never across the middle of a panel. The fourth generation has parking sensors in every trim, so the film is cut around each sensor. On earlier cars only some trims have sensors, which changes the cutting plan.
A camo and patterned wrap on the Vantage is removable by a professional installer without leaving adhesive on the paint. Care is a hand wash with a soft mitt and a mild automotive soap. Brushed metal and camouflage films both need the same gentle washing. Do not use pressure washers close to edges or automatic car washes with brushes.


