The first decision for an Audi A7 wrapped in silver is the finish, because matte, satin and gloss change how the color change reads on this car's long liftback body. A matte silver hides panel waves and looks almost like a fine powder coat, while a gloss silver deepens the reflections along the quarter panels. A satin silver lands between the two, with a soft sheen that does not mirror the surroundings. The finish you pick also decides which films in the picker are available for your installer.

The condition of the factory paint decides how much preparation a silver wrap needs, because every chip, scratch and deep swirl will read through a light color. A silver film on a dark car also shows every edge and gap more than a dark film would, so the installer may paint the door jambs or use knifeless tape for cleaner lines. On both generations the bumper sensors and cameras are cut around, and those cuts are more visible on silver, so the layout of seams matters before the first panel is laid.

The wrap is removable and the care is a hand wash, so the silver film stays on the paint without bonding to it. Use a pH-neutral soap and a soft mitt, and avoid automatic car washes with brushes, which can lift the edges of the film. A hand wash with clean water is enough for a daily-driven A7, and the film should not be pressure washed at the edges. No wax or sealant is needed on top of the wrap.