Choosing an Audi Q7 wrapped in silver starts with the finish, because matte, satin, and gloss read differently on large flat panels. The film choice comes next: a cast film with low initial tack helps on the tall doors and tailgate. After that, decide between a full wrap and a partial color change that leaves the roof or bumpers in the factory color.
Silver wrap film shows factory paint at every shut line unless the jambs are wrapped as a separate job. The Q7 tailgate has the rear glass in it, so the film ends cleanly at the edge of the glass without a visible seam on the outer skin. Parking sensors in the bumpers are cut around on every trim, and the film edge sits exactly at the sensor ring.
A silver wrap on the Q7 is removable, so the factory paint stays as the base for a later color change. Hand wash the film with a soft mitt and pH-neutral soap, and avoid automated brushes that can lift an edge. Rinse road salt from the lower doors and tailgate before it dries, because silver shows white salt marks clearly.

