A BMW 4 series wrapped in black starts with choosing a finish: matte, satin, gloss, or a special effect like metallic or pearl. Then pick the film line, because the same finish handles differently across brands and some install flatter on this car's curves. Decide between a full color change and a partial wrap, since black can work as an accent on the hood or roof. The body style matters too: a convertible has a fabric top that is not wrapped, while a liftback has a tailgate with glass that defines the film edge.
Factory paint under a black wrap stays hidden, so the original color only shows in door jambs and tight gaps unless you cover those too. The car's length of 187.7 in (4,768 mm) to 188.3 in (4,783 mm) on the second generation means seams are placed along natural lines or panel edges. On a liftback, the film ends at the edge of the rear glass, so the installer cuts a clean line there. Some trims have parking sensors, and the film is cut around each sensor so the system keeps working.
Black wrap film is removable, and when installed on healthy factory paint it pulls off without taking the clearcoat with it. Hand wash with a mild soap and soft sponge, because brushes and automatic car washes can lift edges on this car's recessed areas. Avoid high-pressure water aimed at film edges around the sensors, cameras, or the tailgate glass. The wrap needs no wax or sealant; a wrap-specific detail spray keeps the black finish even.
