An Escalade wrapped in color shift film starts with choosing a finish, then a film line and finally a full or partial color change. Every finish here is a color shift, so the decision is which part of the spectrum you want and how strong the iridescence should be. On the fifth generation, the glass roof stays dark, which changes how the color shift reads on the top of the car. In the end, pick a film from this page and plan with your installer which panels get wrapped.

Factory paint shows through nowhere on a full wrap, because every panel is covered edge to edge with film. The only seams you might notice are where film panels meet, and a good installer hides them along body lines. On the Escalade, the body is tall and long, so seams are placed to avoid stretching the film too much. The original paint stays protected underneath and returns when the film is removed.

Color shift film is removable, so you can go back to the factory paint or change the look later. A hand wash is the safest way to clean a wrapped Escalade, because brushes and harsh chemicals can lift or scratch the film. Use a soft sponge and a mild detergent, and rinse well. Since the film is thin, hand washing also lets you check for edges that need attention.