Every Fulwin T11 wrapped in pink starts with a color change plan that sets the finish and the film line first. The finish is the surface look: matte, satin, gloss, or a metallic and pearl effect. The film line is the product family a shop works with, because each line has its own release liner and adhesive system that affect installation. The installer then measures the body and orders enough film to avoid visible color shifts between panels.
Factory paint is the base for any Fulwin T11 wrap, so the paint must be clean and free of chips or peeling clear coat before film goes on. The wrap uses heat to stretch over contours, and installers place seams where a panel ends or where trim covers the edge. On a full color change wrap, the door jambs are often left in the factory color unless the owner asks for them to be wrapped as well. Seams on the tailgate end at the edge of the rear glass, following the body line.
A pink wrap on the Fulwin T11 is removable, and a professional removal usually leaves the factory paint as it was before. The film is not permanent paint, so hand washing is the safest way to clean it without lifting an edge. Pressure washing is possible but the nozzle must stay away from film edges and seams. The wrap is a separate layer that protects the paint under it while it is on the car.