A Tiggo 4 wrapped in gray starts with picking the finish because matte, satin and gloss change the look of the body. Film choice matters next since each brand cuts and lays differently on the Tiggo 4's bumper sensors and tailgate. You can cover the whole body, or combine a gray roof and hood with the factory paint. Partial wraps use the same film as a full color change but need less material.

Factory paint stays visible only if it is clean and smooth before the gray film goes on. Seams are placed along the Tiggo 4's body lines so they stay tight at the edges. The wrap follows the shape of the doors and the rear glass without lifting at the cut lines. A good installer trims around each parking sensor so the film lies flat on the bumper.

A gray wrap on the Tiggo 4 is removable and leaves the factory paint as it was. Hand wash the car with a soft sponge and avoid automatic brushes that catch film edges. Use a pH-neutral soap and rinse the seams gently so water does not lift the film. Small dirt spots come off with a microfiber cloth and no pressure wash at the edges.