A Chrysler 300C wrapped in color shift film starts with the finish you want from white, gray, black, pink, gold, red, purple, blue or green shifts. The finish makes the same body look brighter, deeper or more metallic without changing the color change effect. Then pick one of the 146 films in that finish for its exact flip between two or more tones. A full color change wrap covers every painted panel, while the door jambs stay in factory paint unless you pay for that extra work in the door openings.

The factory paint on a Chrysler 300C stays hidden under the wrap, but the film follows its shape and the condition of the clear coat. Deep scratches, stone chips and peeling paint show through the film, so the best prep is a clean, smooth, original surface. The second generation from 2011 onward is long enough that a full roof needs one wide roll, and seams land only where body lines allow a clean cut. On every trim the installer runs the film up to the edge of each light, camera and sensor, not over it.

A color shift wrap is removable: when the film comes off, the factory paint underneath is the same as before the wrap. A clean removal needs a controlled pull and a little heat, not a knife against the panel. Wash the wrapped Chrysler 300C by hand with a soft mitt and pH-neutral soap. Avoid automated brushes and pressure washers aimed at film edges, because they lift the wrap at the cut lines.