Wraps by car

Cord L-29 wrap

The Cord L-29 wrap covers the entire exterior of this 1929–1932 luxury car. The catalog lists one generation, with a body length of 177.2 in (4,500 mm). A full vinyl wrap of the body uses about 52 ft (16 m) of 60-inch (1.52 m) cast film, or about 57 ft (17.5 m) for chrome or patterned film.

1generations16 mof film for a full wrap

Cord L-29, first generation, factory photo
Cord L-29, first generation. Factory color shown.

Cord L-29 wrap colors and ideas

  • Cord L-29 black wrap
  • Cord L-29 white wrap
  • Cord L-29 gray wrap
  • Cord L-29 silver wrap
  • Cord L-29 red wrap
  • Cord L-29 blue wrap
  • Cord L-29 green wrap
  • Cord L-29 yellow wrap
  • Cord L-29 orange wrap
  • Cord L-29 purple wrap
  • Cord L-29 pink wrap
  • Cord L-29 teal wrap
  • Cord L-29 brown wrap
  • Cord L-29 gold wrap
  • Cord L-29 chrome wrap
  • Cord L-29 color shift wrap
  • Cord L-29 carbon fiber wrap
  • Cord L-29 camo and patterned wrap

How much vinyl to wrap a Cord L-29

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1929–1932convertible (2 or 4 doors)177.2 in (4,500 mm)about 52 ft (16 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 57 ft (17.5 m)

Cord L-29 wrap cost factors

The Cord L-29 wrap cost depends on the film type and the body condition. A full wrap of this 177.2 in (4,500 mm) car needs about 52 ft (16 m) of cast film, or about 57 ft (17.5 m) for chrome or patterned film. The convertible top adds labor because the film must be cut and sealed at its edges. Preparation of old paint on a car from 1929–1932 can also influence the final cost.

  • Film for a full wrap: about 52 ft (16 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 57 ft (17.5 m).
  • Body: convertible (2 or 4 doors).
  • Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Cord L-29 wraps by generation

Swipe sideways. Tap a card for the full description.

Cord L-29, first generation, factory photo
Factory color shown

1929–1932 Cord L-29 convertible (first generation)

1929–1932convertible (2 or 4 doors)177.2 in (4,500 mm)

The open top of the first generation Cord L-29 is not covered with film. The fabric top is left as is, and the vinyl wrap ends where the top begins. If the car has a folding hard top, that top is wrapped as panels of its own. The installer trims the film along the top edge to create a clean line.

Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Film: about 52 ft (16 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 57 ft (17.5 m).

Roof, hood, chrome delete and PPF on a Cord L-29

A partial wrap on a Cord L-29 can cover the hood, mirror caps, or rear deck. Those areas use less film than a full wrap and still change the look of the car. A chrome delete covers the window trim and badges with black film. Paint protection film (PPF) is another option: a clear film on the front end guards against stone chips.

  • Partial wrap: hood, mirror caps, rear deck.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Cord L-29: body, cut-outs and film

The Cord L-29 vinyl wrap suits its convertible body styles with two or four doors. The body length of 177.2 in (4,500 mm) is near the upper end for its class, so the installer handles large panels. A full wrap calls for planning around the open top and the long hood. The film estimate of about 52 ft (16 m) reflects the body area without the fabric top.

Cord L-29 wrap ideas include covering the body and leaving the bright trim exposed. The convertible body means the fabric top is not wrapped and the film ends where it begins. A folding hard top, if fitted, is wrapped as panels of its own. Door handles, hinges and side lights need cut-outs for a clean finish.

How much vinyl to wrap a Cord L-29 depends on the single generation listed. The production years 1929–1932 saw little change in the body shape, so the film estimate stays consistent. A convertible with two doors and one with four doors use nearly the same amount of film. Anyone counting film for this Cord can work from the published figure of about 52 ft (16 m).

Questions about wrapping a Cord L-29

How much vinyl does it take to wrap a Cord L-29?

It takes about 52 ft (16 m) of 60-inch (1.52 m) cast film to wrap a Cord L-29. For chrome or patterned film, the figure is about 57 ft (17.5 m). These estimates cover the full body of the 1929–1932 convertible. The fabric top is not included in the film count.

Is the top of a Cord L-29 wrapped?

No, the top of a Cord L-29 is not wrapped when it is the fabric convertible top. The film ends where the top begins, and the top remains its original material. If the car has a folding hard top, that top is wrapped as panels of its own. The wrap does not cover the fabric top.

Can I wrap only the hood or the roof of a Cord L-29?

Yes, you can wrap only the hood or the roof of a Cord L-29. A partial wrap can be limited to the hood, mirror caps, or rear deck. For the roof, only a folding hard top is wrap material; the fabric top is not wrapped. A partial job uses less film than a full wrap.

Is a Cord L-29 hard to wrap?

A Cord L-29 is not the easiest car to wrap because of its open top and large panels. The fabric top means the film must be cut and finished along its edge. The body length of 177.2 in (4,500 mm) calls for long pieces of film. A folding hard top adds separate panels that need alignment.