Choosing an Atrai wrapped in color shift film starts with the finish, because each finish changes how the shift behaves in daylight. A gloss film gives the strongest color change, while a satin or matte film softens the effect into a more muted color change. After the finish, pick a film from the group that matches the base tone you want. The last decision is full or partial coverage, and on this van the roof and hood are the panels people wrap first.
Factory paint condition matters before any color shift film goes on, and the Atrai’s large flat panels show every flaw under the film. Fix chips and deep scratches first, because vinyl will not hide them and may lift over rough spots. The body has no sharp character lines, so a single panel can be wrapped with fewer seams. On the sliding doors the film is cut along the tracks, which leaves a clean edge without visible seams.
A color shift wrap on the Atrai is removable, and when the time comes the film can be taken off without changing the paint underneath. During its life, hand wash the van with a soft sponge and a mild soap, and avoid automatic car washes with brushes. High-pressure water should be kept away from the door track edges where the film ends. This kind of care keeps the edges down and the color shift looking even.
