Choosing a DS 3 silver wrap starts with finish, because matte, satin, and gloss change how the car's lines read. Then pick a film line whose color and texture you like, since silver ranges from bright white-silver to deep titanium. Decide between a full color change wrap and partial pieces like a hood or roof, depending on budget and the look you want. The DS 3's short overhangs and simple surfaces make most silver films easy to plan.
Factory paint affects a DS 3 wrap mostly through its condition and color. If the original paint is silver, door jambs and edges will match better and small gaps in film are less visible. Seams on a 60-inch (1.52 m) roll usually fall along panel edges, though a hood wider than 5 ft (1.52 m) may need an inlay. A tailgate with glass in it means film ends at the glass edge, which keeps the wrap looking neat.
The DS 3 silver wrap is removable when you decide to change color or sell the car. Hand wash the wrapped car with a soft mitt and pH-neutral soap to protect the film's surface. Avoid high-pressure washing close to edges and sensors, because water can lift the film. Following this simple care keeps the silver wrap smooth and intact.