An Exeed TX wrapped in color shift film starts with choosing the finish that gives the color change you want. Among the finishes on this page, each film bends light differently, so the same body looks more or less dramatic from different angles. Then pick a film line: all films here are cast vinyl, but some color shift films have a pearl or glitter layer. Full or partial wrap is the final decision, and it changes how much film and labor the job needs.
Factory paint stays hidden under a color change wrap, but it still matters for the result. Any chip or scratch will show through the film as a bump, so repair them before the film goes on. Seams are placed at panel edges and along body lines, and a good installer keeps them tight. On the Exeed TX, the tailgate carries the rear glass, so the film ends at the edge of the glass.
Color shift film on the Exeed TX is removable when you want a change or at the end of a lease. Use a heat gun to soften the adhesive and pull slowly to avoid leaving residue. Wash the wrapped car by hand: pressure washers can lift edges, and automatic car washes may scratch the film. A gentle hand wash keeps the color shift effect clean and bright.