A Midi wrapped in color shift film starts with choosing between gray and black, pink and orange, or purple and blue shifts. This color change wrap must run one direction across every panel so the shift pattern stays continuous. For the Midi's flat sides, a gloss finish shows the color travel best in direct light. The sliding door tracks stay bare, so the film edge runs cleanly along them.
Factory paint under the wrap decides how visible the color shift is and where seams fall. Darker paint hides the vinyl's edge better, while light paint shows more contrast at door shuts. The Midi's slab sides allow wide panels with few seams, except at the sliding door tracks. Every seam is planned where body lines already exist.
Color shift vinyl is removable with heat, and hand wash keeps the flake effect sharp. The film peels off without tearing when warmed evenly, and adhesive residue cleans with isopropyl alcohol. Brushes or high-pressure jets can lift edges on the Midi's sliding door areas. A gentle hand wash is enough.

