Choosing a GAC GS4 wrapped in red starts with the finish, then the film, then full or partial coverage. Pick matte, satin or gloss first because it sets the color change tone for the whole vehicle. Then choose a film with an air egress liner for cleaner installation. Finally decide whether to wrap every painted panel or leave some areas stock.

Factory paint should be clean, smooth and free of chips before the film goes on. Any damage shows through the wrap, and sharp edges can cut the film. Seams land at body lines and panel gaps, never across the middle of a flat panel. On the GAC GS4 the tailgate film ends at the edge of the rear glass.

A red wrap on a GAC GS4 is removable, leaving the paint underneath as it was. Removal is easier when the film is in good condition and the right technique is used. Hand wash the wrapped car with a soft sponge and a mild detergent. Avoid automatic brushes and pressure washers close to edges.