The first decision for a HiPhi A wrapped in carbon fiber film is the finish: 74 films carry a carbon weave and 27 a forged carbon look. A color change wrap covers the factory paint fully, so the film’s pattern becomes the new exterior. On the HiPhi A, the rear glass sits in the tailgate, so the film ends at the glass edge and the pattern must run straight there. After the finish, pick a film line from the list above.

The HiPhi A’s factory paint color stays visible in the shut lines and the door jambs unless those are wrapped separately. A full wrap ends at every panel edge, and the seams of the film sit in the panel gaps exactly where they close. On this car the charge port door is wrapped as its own small piece, so its weave should line up with the rear fender. That keeps the whole side looking like one surface.

Carbon fiber film on the HiPhi A is removable and comes off with heat and a steady pull, returning the car to its original paint. A hand wash is the safe way to clean the wrap, with a soft mitt and no pressure washer on the edges. Avoid automatic brushes, because they can lift a seam or scratch the film. The charge port door edge is the spot to watch when washing.