A Guoya wrapped in green is a full color change that covers the factory finish with pressure-activated vinyl film. Start with the finish, since matte, satin and gloss greens read very differently on this long sedan body. Then pick a film line that your installer can lay smoothly over the doors and deep front fenders. Decide at the end whether to wrap the door jambs and inner edges or leave them in the original color.

Factory paint under a wrap stays protected from stone chips and light scuffs, but it must be clean and smooth before the film goes on. Any rust, deep scratch or paint chip shows through the vinyl, so repairs should happen before the color change. Seams are planned along panel edges and body lines, and on the Guoya the installer can hide most of them in the door gaps. A good shop will not stretch a single piece over the whole roof and will place seams where they look intentional.

A green wrap on the Guoya is removable and does not bond chemically to the clearcoat beneath it. When the film is removed correctly, the factory paint underneath is the same as before the wrap. Hand wash the car with pH-neutral soap and a soft mitt, and avoid automatic brushes or pressure washers aimed at edges. This keeps the film clean and the edges down.