Wraps by car

International Travelall wrap

This page covers the International Travelall, a full-size SUV produced in one cataloged generation from 1969 to 1975. A complete color change wrap on that body takes about 69 ft (21 m) of 60-inch (1.52 m) cast film. The Travelall is a five-door SUV with a length of 203.9 in (5,179 mm). Use a chrome or patterned film and the estimate rises to about 77 ft (23.5 m).

1generations21 mof film for a full wrap

International Travelall, fourth generation, factory photo
International Travelall, fourth generation. Factory color shown.

International Travelall wrap colors and ideas

  • Travelall black wrap
  • Travelall white wrap
  • Travelall gray wrap
  • Travelall silver wrap
  • Travelall red wrap
  • Travelall blue wrap
  • Travelall green wrap
  • Travelall yellow wrap
  • Travelall orange wrap
  • Travelall purple wrap
  • Travelall pink wrap
  • Travelall teal wrap
  • Travelall brown wrap
  • Travelall gold wrap
  • Travelall chrome wrap
  • Travelall color shift wrap
  • Travelall carbon fiber wrap
  • Travelall camo and patterned wrap

How much vinyl to wrap an International Travelall

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1969–1975SUV (5 doors)203.9 in (5,179 mm)about 69 ft (21 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 77 ft (23.5 m)

Travelall wrap cost factors

Travelall wrap cost depends first on the film coverage, because a full wrap of this 203.9 in (5,179 mm) SUV needs about 69 ft (21 m) of 60-inch (1.52 m) cast film. The choice of chrome or patterned film increases the material to about 77 ft (23.5 m) and adds layout time. Surface preparation matters on a car built from 1969 to 1975, where paint condition varies and panels may need extra cleaning. Labor for removal of trim, badges and the tailgate glass edge work also changes the final figure.

  • Film for a full wrap: about 69 ft (21 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 77 ft (23.5 m).
  • Body: SUV (5 doors).
  • A tailgate with the rear glass in it: the film ends at the edge of the glass.

Travelall wraps by generation

Swipe sideways. Tap a card for the full description.

International Travelall, fourth generation, factory photo
Factory color shown

1969–1975 Travelall SUV (fourth generation)

1969–1975SUV (5 doors)203.9 in (5,179 mm)

The 1969–1975 International Travelall is the fourth generation in the model's history and the only one covered on this page. Paint age is a key factor on a vehicle of these years, because panels may be original or repainted, and a test spot comes before a full wrap. The body is a 203.9 in (5,179 mm) five-door SUV with a rear tailgate that includes the glass. A full wrap of this generation takes about 69 ft (21 m) of 60-inch (1.52 m) cast film.

A tailgate with the rear glass in it: the film ends at the edge of the glass.

Film: about 69 ft (21 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 77 ft (23.5 m).

Roof, hood, chrome delete and PPF on a Travelall

For a smaller job than a full Travelall wrap, a partial wrap can cover the roof, hood or mirror caps. Chrome delete on a Travelall covers the window trim and badges with black film for a cleaner look. Paint protection film (PPF) can be applied as clear film on the front end to guard against stone chips. These options use less material and can focus on the areas that see the most wear.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping an International Travelall: body, cut-outs and film

An International Travelall vinyl wrap has to cover a large, mostly flat-sided body with a 203.9 in (5,179 mm) length. The five-door SUV layout means long roof and quarter panels, so a full wrap uses wide 60-inch (1.52 m) film efficiently. Panel gaps are simple and the sides are upright, which reduces waste but calls for careful trimming at the door edges. The rear tailgate is a single large piece that adds most of the extra area over a sedan.

Travelall wrap ideas often start with the tailgate, because the rear glass is set into it and the film must end cleanly at the edge of that glass. The wrap installer cuts around the glass rather than removing it, so the tailgate needs a precise inlay. Door handles, badges and the side mirrors are removed or cut out for a neat edge. The roof gutters and window trim are simple enough to wrap without removing the glass.

If you want to know how much vinyl to wrap a Travelall, the only generation in this catalog is the 1969–1975 body at 203.9 in (5,179 mm). A full wrap with solid cast film takes about 69 ft (21 m) of 60-inch (1.52 m) material. Choosing chrome or patterned film for the same body raises the estimate to about 77 ft (23.5 m) because of pattern matching. No earlier or later body style appears here, so the figure does not change across years.

More International wraps

Questions about wrapping an International Travelall

How much vinyl does it take to wrap an International Travelall?

It takes about 69 ft (21 m) of 60-inch (1.52 m) cast film to wrap an International Travelall. That estimate is for the 1969–1975 body, which is 203.9 in (5,179 mm) long. If you choose a chrome or patterned film, the amount rises to about 77 ft (23.5 m) because of pattern alignment. The figure covers a full exterior wrap on the five-door SUV.

Can I wrap only the hood or the roof of a Travelall?

Yes, you can wrap only the hood or the roof of a Travelall as a partial wrap. The partial wrap options for this vehicle include the roof, hood and mirror caps. You can also do a chrome delete on the window trim and badges or add clear paint protection film (PPF) to the front end. A partial job uses less film than the full 69 ft (21 m) estimate.

Is a Travelall hard to wrap?

A Travelall is not especially hard to wrap, but its size and the rear tailgate add work. The body is 203.9 in (5,179 mm) long, so you need large panels and a second pair of hands. The tailgate has the rear glass set into it, and the film must end cleanly at the edge of that glass, which requires careful trimming. The upright sides and simple lines of this 1969–1975 SUV make the main panels straightforward.

How many generations of the Travelall does this page cover?

This page covers one generation of the International Travelall, from 1969 to 1975. That generation is the fourth in the Travelall's history, but the catalog only includes this single body style. The vehicle is a full-size five-door SUV with a length of 203.9 in (5,179 mm). No other generations of the Travelall are described here.