Start a J7 (Binyue) wrapped in silver by choosing a finish, then a film line, then full or partial coverage. A matte finish hides small panel marks better, while a gloss finish matches factory paint depth. The color change wrap itself is removable, so you are not tied to one look.
Factory paint on this car is often fine after all these years, but some panels may have been repainted. Any repaint needs to be fully cured before film goes on, or lifting can occur. Seams are placed along panel edges and body lines, so they stay out of direct sight.
The film is removable when the time comes, and it leaves the paint underneath as it was. Wash a wrapped J7 (Binyue) by hand with a soft mitt and mild soap, never a pressure washer at close range. Keeping dirt off the edges helps the film stay down.


