The first decision for an Alto wrapped in silver is the finish, because matte, satin, gloss, metallic and candy look different on the same panels. Then pick a film line within that finish: the page lists every silver film by name, and the number of choices grows as the catalog adds brands. After that, decide between a full color change and a partial wrap on the roof or hood. A silver color change reads more strongly on the Alto when the door handles and mirror caps are included in the plan.

Any factory paint under a silver wrap needs to be clean and smooth before the film goes on. The Alto's tailgate carries the rear glass, so the film ends at the edge of the glass and the installer plans the seams there. Seams are also needed around the door handles and the fuel flap, and a good shop places them out of sight. On a repainted panel the paint must be cured and solid, or the film can lift the coating.

A silver wrap on the Alto is removable when the film is cast and the job is done correctly. Hand wash the car with a soft sponge and a mild soap, and avoid automatic brushes that can lift an edge. The tailgate seam where the film stops at the glass is the spot to watch: keep it clean and free of wax. Removal later goes back to the original paint when the panel was in good condition from the start.