A Leapmotor T03 wrapped in black starts with choosing a finish for the color change. Matte, satin and gloss black each sit differently on the T03's short, upright body. The finish changes how the wrap picks up light along the tailgate and the edges of the front bumper. Your choice of finish is the first decision for this car.

Factory paint matters more than the wrap film when you plan the panel lines. The T03 has a tailgate with the rear glass in it, and the film ends at the edge of the glass, so the roof and the tailgate meet at clean seams. Parking sensors and cameras sit in the bumpers on every trim, and the installer cuts the film around each one. Those cut lines are small and stay neat when the surface is clean and dry.

The film on a T03 is removable and the paint under it stays safe when you hand wash the car. Use a mild soap and a soft mitt over the wrapped panels. Dirt collects at the seams around the charge port door and the sensor cutouts, so rinse those areas slowly. No pressure washer at the edge of the film on the roof rails or around the glass.