A Lexus IS wrapped in black starts with choosing the finish, then the film, then full or partial coverage. Matte black hides reflections and gives the body a smooth, flat appearance. Satin black sits between matte and gloss with a low sheen. Gloss black is the closest film to a deep factory clearcoat. The film line you pick controls the look, and the amount of film depends on the body.
Factory paint color still matters because a wrap cannot hide damage. Dents, deep scratches and peeling clearcoat show through the film. Seams are placed along body lines and panel edges, not across large flat areas. On the Lexus IS, the front and rear bumpers are one piece, so seams run only where the bumpers meet the fenders and quarter panels. Good paint preparation gives the film a clean surface to bond to.
A black wrap on the Lexus IS is removable. Removal is cleaner when the film is taken off by a shop with the right tools and heat. Hand wash the car with a soft mitt and pH-neutral soap, and avoid pressure washers aimed at edges. The wrap will lift if a pressure washer is held too close to a seam.

