Wraps by car

Maybach Exelero wrap

The Maybach Exelero wrap page covers the one-off Maybach Exelero sports car, built in a single generation for 2005. This long two-door coupe measures 231.9 in (5,890 mm) from nose to tail. A full vinyl wrap of the body takes about 64 ft (19.5 m) of 60-inch (1.52 m) cast film. Chrome or patterned film adds up to about 84 ft (25.5 m) for the same coverage.

1generations19.5 mof film for a full wrap

Maybach Exelero, first generation, factory photo
Maybach Exelero, first generation. Factory color shown.

Maybach Exelero wrap colors and ideas

  • Exelero black wrap
  • Exelero white wrap
  • Exelero gray wrap
  • Exelero silver wrap
  • Exelero red wrap
  • Exelero blue wrap
  • Exelero green wrap
  • Exelero yellow wrap
  • Exelero orange wrap
  • Exelero purple wrap
  • Exelero pink wrap
  • Exelero teal wrap
  • Exelero brown wrap
  • Exelero gold wrap
  • Exelero chrome wrap
  • Exelero color shift wrap
  • Exelero carbon fiber wrap
  • Exelero camo and patterned wrap

How much vinyl to wrap a Maybach Exelero

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
2005–2005coupe (2 doors)231.9 in (5,890 mm)about 64 ft (19.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 84 ft (25.5 m)

Exelero wrap cost factors

Exelero wrap cost depends on the film quantity and the time to work around a 231.9 in (5,890 mm) body. A full wrap uses about 64 ft (19.5 m) of 60-inch (1.52 m) cast film, and chrome or patterned film raises that to about 84 ft (25.5 m). The one-off coupe shape and the two long doors add labor compared with a shorter car. Surface preparation also changes the cost if the 2005 paint needs correction.

  • Film for a full wrap: about 64 ft (19.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 84 ft (25.5 m).
  • Body: coupe (2 doors).
  • Two long side doors: each door is one large piece of film.

Exelero wraps by generation

Swipe sideways. Tap a card for the full description.

Maybach Exelero, first generation, factory photo
Factory color shown

2005–2005 Exelero coupe (first generation)

2005–2005coupe (2 doors)231.9 in (5,890 mm)

The first generation Maybach Exelero was produced only in 2005, so paint age varies from car to car. Panels may be original or repainted after nearly two decades, and a test spot comes before a full wrap. The wrap installer checks adhesion on each panel before laying the 60-inch (1.52 m) cast film. This step protects the paint and shows where extra prep is needed.

Two long side doors: each door is one large piece of film.

Film: about 64 ft (19.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 84 ft (25.5 m).

Roof, hood, chrome delete and PPF on an Exelero

Partial wrap on an Exelero covers the roof, hood, and mirror caps in film. A chrome delete takes the window trim and badges from bright to black. Paint protection film (PPF) puts a clear layer on the front end to shield the nose and hood. These smaller jobs use less of the 60-inch (1.52 m) film than a full 64 ft (19.5 m) wrap.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film on the front end, also over a wrap.

Wrapping a Maybach Exelero: body, cut-outs and film

A Maybach Exelero vinyl wrap follows the shape of a very long coupe with two large side doors. The body is 231.9 in (5,890 mm) long, so the roof and rocker panels run longer than on most sports cars. Each door is one large piece of film, which keeps the sides clean and free of seams. The wrap has to bridge the long quarter panels and the rear deck without distortion.

Exelero wrap ideas start with the long side doors, because each door is one large piece of film. A chrome delete covers the window trim and badges with black film for a tighter look. Mirror caps and the roof can be wrapped on their own as a partial job. Cut-outs are needed around the door handles, badges, and the fuel filler area.

How much vinyl to wrap an Exelero depends on the body of this single generation. The coupe is 231.9 in (5,890 mm) long, and the full wrap takes about 64 ft (19.5 m) of 60-inch (1.52 m) cast film. A chrome or patterned film job needs about 84 ft (25.5 m). There are no other generations to compare, so this figure covers every Exelero made in 2005.

Questions about wrapping a Maybach Exelero

How much vinyl does it take to wrap a Maybach Exelero?

A Maybach Exelero wrap takes about 64 ft (19.5 m) of 60-inch (1.52 m) cast film for a full color change. If the film is chrome or patterned, the amount goes up to about 84 ft (25.5 m). These figures come from the single coupe body of the 2005 generation.

Can I wrap only the hood or the roof of an Exelero?

Yes, you can wrap only the hood or the roof of an Exelero. The partial wrap list for this car names the roof, hood, and mirror caps as separate jobs. A chrome delete is another option, covering the window trim and badges. Paint protection film (PPF) on the front end is a clear alternative to a color change.

Is an Exelero hard to wrap?

Yes, an Exelero is hard to wrap because of its size and door design. The body is 231.9 in (5,890 mm) long, so panels like the roof and rockers need very long pieces of film. Each side door is one large piece of film, which must be laid without wrinkles or stretch marks. The one-off coupe shape has few flat areas, and the 2005 paint may need extra prep.

How many generations of the Exelero does this page cover?

This page covers one generation of the Maybach Exelero. The catalog lists the first generation, produced in 2005, as the only body style. There are no other generations for this one-off sports car.