A Mazda MX-5 wrapped in gray gives a color change without repainting the factory paint. Start by choosing the finish, then pick a film from that finish, and decide on a full wrap or partial coverage. Gray hides dust well and changes tone with the light, so the same film looks different at noon and at dusk. Every finish on this page works on all four generations of the MX-5 from 1989 to now.

Factory paint on the Mazda MX-5 is your base and must be clean and smooth before any film is applied. On a car this small, panel shapes are simple and the wrap can be cut with few seams. A good installer will place seams along body lines so they are hard to see. Repair or repaint of a panel changes its surface and may mean the film is applied only after that work is done.

A gray wrap on the Mazda MX-5 is removable and you can go back to the original color later. Wash it by hand with a soft sponge and a mild cleaner; automatic brush washes can lift edges. Dirt around the door handles and the rear deck lip is best cleaned with a detail spray. No special wax is needed on matte and satin films.