Wraps by car

Mega Monte Carlo wrap

The Mega Monte Carlo wrap page covers the 1996–1999 first generation and the vinyl wrap it needs. A full wrap of this coupe takes about 49 ft (15 m) of 60-inch (1.52 m) cast film. Chrome or patterned film brings that figure to about 57 ft (17.5 m). The catalog shows one generation of this sports car.

1generations15 mof film for a full wrap

Mega Monte Carlo, first generation, factory photo
Mega Monte Carlo, first generation. Factory color shown.

Mega Monte Carlo wrap colors and ideas

  • Monte Carlo black wrap
  • Monte Carlo white wrap
  • Monte Carlo gray wrap
  • Monte Carlo silver wrap
  • Monte Carlo red wrap
  • Monte Carlo blue wrap
  • Monte Carlo green wrap
  • Monte Carlo yellow wrap
  • Monte Carlo orange wrap
  • Monte Carlo purple wrap
  • Monte Carlo pink wrap
  • Monte Carlo teal wrap
  • Monte Carlo brown wrap
  • Monte Carlo gold wrap
  • Monte Carlo chrome wrap
  • Monte Carlo color shift wrap
  • Monte Carlo carbon fiber wrap
  • Monte Carlo camo and patterned wrap

How much vinyl to wrap a Mega Monte Carlo

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1996–1999coupe (2 doors)175.2 in (4,450 mm)about 49 ft (15 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 57 ft (17.5 m)

Monte Carlo wrap cost factors

Monte Carlo wrap cost depends on the condition of the 1996–1999 paint and the amount of cut-outs. A coupe with two long doors uses about 49 ft (15 m) of 60-inch (1.52 m) cast film, and more if the film is chrome or patterned. Paint that is original or repainted needs a test spot before the wrap goes on. The installer's labor for laying large door panels also affects the total.

  • Film for a full wrap: about 49 ft (15 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 57 ft (17.5 m).
  • Body: coupe (2 doors).
  • Two long side doors: each door is one large piece of film.

Monte Carlo wraps by generation

Swipe sideways. Tap a card for the full description.

Mega Monte Carlo, first generation, factory photo
Factory color shown

1996–1999 Monte Carlo coupe (first generation)

1996–1999coupe (2 doors)175.2 in (4,450 mm)

The first generation Mega Monte Carlo ran from 1996 to 1999 as a two-door coupe. Paint on a car of these years may be original or repainted, so a test spot comes before a full wrap. The body is 175.2 in (4,450 mm) long and uses about 49 ft (15 m) of 60-inch (1.52 m) cast film. Each long door is one large piece of film.

Two long side doors: each door is one large piece of film.

Film: about 49 ft (15 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 57 ft (17.5 m).

Roof, hood, chrome delete and PPF on a Monte Carlo

A partial wrap on the Mega Monte Carlo can cover the roof, hood, or mirror caps. Chrome delete on this car means covering the window trim and badges with black film. Paint protection film (PPF) is clear film applied to the front end. These smaller jobs use less film than a full wrap.

  • Partial wrap: roof, hood, mirror caps.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Mega Monte Carlo: body, cut-outs and film

The Mega Monte Carlo vinyl wrap suits a two-door coupe that measures 175.2 in (4,450 mm) long. A coupe has fewer door gaps than a four-door, so the side profile stays clean. Each of the two long doors takes one large piece of film, which speeds up installation. The compact overall length still calls for careful panel-by-panel planning.

Monte Carlo wrap ideas start with the two long side doors, each covered in one large piece of film. There are no roof rails or spoilers to remove on this body. Cut-outs for the door handles, mirrors, and badges are straightforward. The wrap installer can keep most trim in place and trim around it.

How much vinyl to wrap a Monte Carlo stays the same across the 1996–1999 first generation. The coupe body did not change shape during those years, so the film estimate holds for every trim. A full wrap uses about 49 ft (15 m) of 60-inch (1.52 m) cast film. Ordering that amount leaves a safe margin for test panels and mistakes.

Questions about wrapping a Mega Monte Carlo

How much vinyl does it take to wrap a Mega Monte Carlo?

A Mega Monte Carlo takes about 49 ft (15 m) of 60-inch (1.52 m) cast film for a full wrap. If you choose chrome or patterned film, plan for about 57 ft (17.5 m). This figure covers the 1996–1999 coupe body.

Can I wrap only the hood or the roof of a Monte Carlo?

Yes, you can wrap only the hood or the roof of a Mega Monte Carlo. A partial wrap on this car may include the roof, hood, or mirror caps. Chrome delete is also possible on the window trim and badges. These jobs use less film than a full wrap.

Is a Monte Carlo hard to wrap?

A Mega Monte Carlo is not especially hard to wrap, but its two long doors add work. Each door is one large piece of film, so the installer must handle long sections without creasing. The car is 175.2 in (4,450 mm) long, which is manageable for a coupe. No roof rails or spoilers need removal.

How many generations of the Monte Carlo does this page cover?

This page covers one generation of the Mega Monte Carlo, the first generation from 1996 to 1999. The coupe body did not change during that run. All film estimates on this page refer to that generation.