Wraps by car

Panoz Roadster wrap

The Panoz Roadster wrap page covers this 1992–1999 sports car in its single generation. A full wrap of this body takes about 39 ft (12 m) of 60-inch (1.52 m) cast vinyl film. Chrome or patterned film increases the needed material to about 49 ft (15 m).

1generations12 mof film for a full wrap

Panoz Roadster, first generation, factory photo
Panoz Roadster, first generation. Factory color shown.

Panoz Roadster wrap colors and ideas

  • Roadster black wrap
  • Roadster white wrap
  • Roadster gray wrap
  • Roadster silver wrap
  • Roadster red wrap
  • Roadster blue wrap
  • Roadster green wrap
  • Roadster yellow wrap
  • Roadster orange wrap
  • Roadster purple wrap
  • Roadster pink wrap
  • Roadster teal wrap
  • Roadster brown wrap
  • Roadster gold wrap
  • Roadster chrome wrap
  • Roadster color shift wrap
  • Roadster carbon fiber wrap
  • Roadster camo and patterned wrap

How much vinyl to wrap a Panoz Roadster

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1992–1999convertible (2 doors)159.1 in (4,040 mm)about 39 ft (12 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 49 ft (15 m)

Roadster wrap cost factors

Roadster wrap cost is driven by the film width and the open-top body of this car. A 60-inch (1.52 m) roll covers the 159.1 in (4,040 mm) body with fewer seams than a narrower roll. Chrome or patterned film raises the material figure to about 49 ft (15 m).

  • Film for a full wrap: about 39 ft (12 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 49 ft (15 m).
  • Body: convertible (2 doors).
  • Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Roadster wraps by generation

Swipe sideways. Tap a card for the full description.

Panoz Roadster, first generation, factory photo
Factory color shown

1992–1999 Roadster convertible (first generation)

1992–1999convertible (2 doors)159.1 in (4,040 mm)

The open top of the first generation Roadster is not wrapped in a vinyl film install. Film ends at the edge where the fabric top begins, leaving the folding mechanism uncovered. A folding hard top, if fitted, would be wrapped as panels of its own.

Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Film: about 39 ft (12 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 49 ft (15 m).

Roof, hood, chrome delete and PPF on a Roadster

A partial wrap on the Roadster covers the hood, mirror caps and rear deck with vinyl. Chrome delete on this car covers window trim and badges with black film. Paint protection film (PPF) can be applied as clear film on the front end.

  • Partial wrap: hood, mirror caps, rear deck.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping a Panoz Roadster: body, cut-outs and film

The Panoz Roadster vinyl wrap follows the convertible body of this 159.1 in (4,040 mm) car. Two doors and the open top shape how the film is laid out on each side. The fabric top is not wrapped, so the film ends where the top begins.

Roadster wrap ideas start with the cut-outs this body requires. Door handles, badges and the side mirrors need openings trimmed in the film. The fabric top is left unwrapped, and the film line runs along its base.

How much vinyl to wrap a Roadster depends on counting film for one generation only. The first generation spans 1992–1999 with the same convertible body length of 159.1 in (4,040 mm). The open top does not need film, which keeps the estimate at about 39 ft (12 m) of cast film.

More Panoz wraps

Questions about wrapping a Panoz Roadster

How much vinyl does it take to wrap a Panoz Roadster?

A Panoz Roadster takes about 39 ft (12 m) of 60-inch (1.52 m) cast film for a full wrap. That figure covers the convertible body from 1992–1999 without wrapping the fabric top. Chrome or patterned film increases the need to about 49 ft (15 m).

Is the top of a Roadster wrapped?

No, the top of a Roadster is not wrapped when the car has its fabric top. The film ends where the top begins, leaving the fabric and its folding mechanism uncovered. A folding hard top would be wrapped as panels of its own.

Can I wrap only the hood or the roof of a Roadster?

Yes, you can wrap only the hood or the roof area of a Roadster as a partial job. A partial wrap on this car includes the hood, mirror caps and rear deck. The roof is not wrapped because the open top has a fabric cover that stays bare.

Is a Roadster hard to wrap?

Yes, a Roadster is harder to wrap than a fixed-roof car of the same size. The convertible body adds work at the point where the film ends at the fabric top. The 159.1 in (4,040 mm) length and cut-outs for handles and badges add more detail work.