A Logan wrapped in color shift film starts with choosing a finish, then a film line, then a full or partial color change. Color shift vinyl has a pearlescent or holographic layer that shifts between two or more tones. On the Logan's flat sides, the effect changes most at the body lines and curves. The film is cut to fit each panel before installation.

The factory paint must be clean, smooth, and free of chips or peeling clear coat before color shift film goes on. Any deep scratch or rust spot will show through the vinyl as a bump or shadow. The Logan has a simple shape, so most panels are wrapped as one piece without seams. The only seams on this car run in the roof channels and around the door handles.

Color shift vinyl is removable, and hand washing the wrapped Logan keeps the finish clean. Use a mild car wash soap and a soft mitt, then rinse with low water pressure. Avoid automatic car washes with brushes, and never use a pressure washer closer than 12 inches. Dirt left on the film can rub against the chameleon layer and dull the shift effect.