The Subaru BRZ wrapped in camo or patterned film starts as a color change decision where the finish is picked before the film. Camouflage hides the body lines, while brushed metal shows every curve of the coupe with a machined sheen. A full wrap keeps the factory paint untouched underneath and is removable when the look changes. The pattern must run one way across the car, and every installer cuts each panel to keep that direction true.

Factory paint on the Subaru BRZ is the base every installer works from, and its condition sets how the film lays down. Stone chips, scratches, or rough repaint edges will read through a patterned film unless they are sanded first. Seams are planned along body lines so the 46 ft (14 m) of film sits with the fewest visible joins. The two long doors mean a seam runs only where the panel ends, never across the middle.

A removable camo or patterned wrap on the Subaru BRZ comes off with heat and leaves no adhesive behind on healthy factory paint. Hand wash only is the rule after the wrap is fitted, because brushes and automatic washes lift edges on grooved patterns. Dirt sits in the texture of brushed metal, so a soft mitt and mild soap are the safe choice. This keeps the film clean without pushing water under the cut edges.