An Outback wrapped in purple starts with a finish decision, because matte, satin, and gloss each change the color's depth. The film brand matters next, as lines differ in shade and in how they handle the Outback's curves. Then decide between a full color change or a partial wrap that leaves some panels in factory paint. Your installer can show you samples of each finish on the actual body.

Factory paint underneath a wrap should be clean and free of chips before the film goes on. Seams are part of a color change wrap, and a good installer plans them along body lines and panel edges. The Outback's tailgate and bumpers are places where seams can be hidden with careful cutting. On this car the film ends at the edge of the rear glass, so that line is a natural seam.

The film is removable, so a purple wrap can be taken back off without leaving adhesive when it is removed correctly. Hand wash the wrapped Outback with a soft sponge and a mild soap. Avoid automatic car washes with brushes, because they can lift the film edges. A pressure washer is safe only at low pressure and from a distance.