Decide on the finish first when planning a color change to a Tacoma wrapped in white. A full wrap on this pickup takes about 70 ft (21.5 m) of 60-inch (1.52 m) cast film for solids, or about 80 ft (24.5 m) for chrome or patterned film. The film wraps the cab and bed as two bodies, leaving the inside of the bed bare. Order the film amount based on the generation you have, as the newest body is the tallest.
Factory paint condition changes how a white wrap looks on the Tacoma. Deep scratches and chips read through thin cast film, so the installer may sand or fill them first. Seams are planned at body lines, the edges of panels, and around the bed, where the film meets bare paint. A wrap does not hide rust or lifting clear coat, since the film follows the surface below.
A white Toyota Tacoma wrap is removable and needs only hand washing to stay clean. Use a pH-neutral soap and a soft mitt, and avoid automated car washes with brushes. Pressure washing is fine from a distance and at a low angle, never at film edges. The wrap protects the paint under it, and removal later does not strip healthy factory paint.


