A Rapide wrapped in black gives a full color change over the factory paint without a repaint. Your first choice is finish: matte, satin or gloss set the character of the car. Then pick a film line, because the brand determines how the vinyl is made and how it behaves during installation. Last, decide between a full wrap and a partial one like a black roof or hood.

Factory paint condition decides how much preparation goes into a black Rapide wrap. Any chip or scratch shows through the vinyl, so paint correction is part of the job before the film goes on. A tailgate with the rear glass in it means the film ends at the edge of the glass, so the wrap has a clean line there. Seams are planned along body lines and around the bumpers, where parking sensors are cut out on every trim.

A black wrap on a Rapide is removable when the film is taken off by hand. The adhesive is designed to release from factory paint, but the condition of the paint underneath matters. After the wrap, hand wash the car and avoid automated brushes to protect the edges of the film. This keeps the black finish looking even across the panels.