An Audi RS6 wrapped in color shift film starts with the finish: 146 films span white, gray, black, pink, gold, red, purple, blue and green shifts. The finish decides the look, because white and gray shifts read subtle while pink and purple shifts are stronger. The next decision is the film itself, and the page groups 37 films under white, gray and black, 16 under pink, gold and red, and 93 under purple, blue and green. The color change is then planned as a full wrap or a partial wrap on selected panels.
Factory paint is the base for the wrap, and the body of the Audi RS6 decides the number of panels and seams. A tailgate with the rear glass in it means the film ends at the edge of the glass on every generation. Every trim of the fourth generation has a panoramic glass roof, roof rails and a styling kit, so the installer removes parts or cuts along them before wrapping. Parking sensors and cameras in the bumpers and body require cut-outs around each one, so seams are planned to avoid these areas.
Color shift film is removable, and on the Audi RS6 the install method leaves the factory paint as it was. The vinyl is cut on the car with the seams placed at panel edges, so the wrap can be taken off later without peeling the paint. A hand wash is the safest way to clean the car: a pressure washer can lift an edge, and a stiff brush can scratch the film. Washing by hand with a mild soap and a soft mitt keeps the color shift clean without pushing dirt under the edges.


