An Audi S7 wrapped in white starts with the finish, then the film line, then full or partial coverage. Matte, satin and gloss films each read differently on the S7's large side panels and the taillight-to-headlight shoulder. The film estimate assumes a full color change, but a partial wrap on the roof, hood or mirror caps uses much less film. For a full-size liftback, the installer must plan the seams around the tailgate and the rear bumper sensors.

Factory paint condition decides how the white wrap lays down on the Audi S7. Stone chips, deep scratches and failing clear coat show through gloss and satin white films more than through matte. Seams are needed on the S7 bumpers because one piece cannot stretch into every recess. On a car this size, the installer may hide the seams along body lines or under the edges of panels.

The wrap is removable by design, and a careful removal leaves the factory paint as it was. The S7 lifts paint on the same principle as a paint protection film, with no paints or solvents on the body. Hand wash is the safe method for any wrapped Audi S7, because high-pressure washes can lift a film edge. The mirror caps, door handles and the tailgate lip are the spots to watch when drying.