A Byvin BD132J wrapped in gray is first a decision about finish, then film, then full or partial coverage. Matte and satin grays look softer on this small hatchback, while gloss grays highlight its curved tailgate. The charge port door and long side doors cut into separate pieces that follow the body lines. Some gray films come in patterned versions that need about 39 ft (12 m) for the BD132J.
Factory paint under a gray wrap only matters if the paint has been repaired. A test spot on each panel shows whether the film will lift old paint or clear coat when removed. Seams on the BD132J fall at the door edges, the tailgate glass line and around the charge port door. Each long side door is one large piece, so seams stay away from the middle of the panel.
A gray wrap on the BD132J is removable when it is removed with low heat and steady tension. Hand wash the car with a soft mitt and pH-neutral soap; avoid automated brushes and pressure washers aimed at edges. The charge port door wrap is a small piece that can be replaced on its own if it lifts. The tailgate film ends at the edge of the rear glass, so that seam stays clean with a wiped edge.


