Start a Raeton wrapped in carbon fiber film by picking the finish: carbon weave, forged carbon, or a tinted black. The finish decides whether the pattern is a regular woven grid or the irregular chips of forged carbon. Then choose a film line, as the same finish appears in both gloss and matte. Finally decide between a full color change and a partial wrap on selected panels.

Factory paint stays untouched under a carbon fiber wrap, so the original color is protected and can be shown again later. The film adds a thin layer that is removed with heat when the time comes. Seams are placed along body lines and panel edges where they are least visible. On a full-size sedan the roof and large side panels need careful seam planning because the film is cut around the sunroof opening and parking sensors on some trims.

A carbon fiber wrap is removable, and the Raeton can go back to its factory finish at the end of the job. Use a hand wash with a soft mitt and a mild car shampoo; a pressure washer is fine at low pressure and a safe distance. Avoid automatic car washes with brushes and do not use solvent-based cleaners on the film.