A Raeton wrapped in color shift film starts with choosing the finish group, then a specific film, then full or partial coverage. The finish determines how intense the shift looks and which angles show it best. On the Raeton’s long hood and flat sides, larger panels let the color change play across more distance. Color change wraps do not hide body damage, so fix dents and deep scratches before wrapping.
Factory paint must be clean, smooth, and fully cured before any wrap, because color shift film reveals every flaw in the surface beneath. On the Raeton, check the leading edge of the hood and the lower doors for stone chips, and sand them level. Seams are placed along body lines and panel edges, so they follow the sedan’s existing creases. A good installer will let you see seam placement before the film is cut.
Color shift film is removable, but it must be pulled off with steady heat and the right technique by someone used to Raeton trim. Hand wash the wrapped car with a soft mitt and pH-neutral soap, and avoid automatic brushes. Do not use a pressure washer closer than 12 inches to edges or seams. If the wrap gets scratched or torn, one panel can be rewrapped without redoing the whole car.
