The IndiS (S18D) wrapped in carbon fiber film starts with a finish choice between carbon weave and forged carbon. Next, pick a film from the page that suits your budget and look, because lines differ in texture and sheen. Then decide between a full color change and leaving some areas like pillars in factory paint. On this hatchback a full wrap covers every painted panel including the tailgate, while a partial job can focus on the roof and hood.
A clean paint surface is the first requirement for fitting carbon fiber film over factory paint. Deep scratches and stone chips need work before film goes on, because the film shows them through its surface. On this car the rear glass sits in the tailgate, so the film ends at the edge of the glass. A test spot on an older or repainted panel tells you whether the paint will hold the film well.
The carbon fiber film is removable, but removal speed depends on the paint underneath and how long the film stayed on. Wash the wrapped IndiS (S18D) by hand with mild soap and a soft mitt, and avoid high-pressure jets near edges. Work slowly around the fog lamp cut-outs in the front bumper, where the film edge can lift. Lifting an edge soon after installation prevents dirt from getting under the film.

