A Blazer wrapped in red starts with the finish: matte red is flat and non-reflective, satin red has a soft sheen, and gloss red shines like clear coat. The film line then decides the exact shade, from bright signal red to deep garnet. A color change wrap covers the painted panels, while door jambs and other hidden areas stay factory color. The newest Blazer has a tailgate with the rear glass in it, so the film ends at the edge of the glass.

Factory paint stays under the film, so any darker areas or damage show if the film is thin. Seams are placed along body lines, panel edges and the roof rails, where the eye accepts them. Some trims have parking sensors in the bumpers, and the film is cut around each sensor. Every trim has roof rails, and they come off before the roof is wrapped, or the film is cut along them.

The film is removable: a professional can take it off and reveal the factory paint, which is not harmed when the wrap is applied correctly. Washing by hand is safer than an automatic brush wash, which can lift edges at the film seams. Use a soft sponge, pH-neutral soap and no pressure washer close to cut lines. A clean, dry wrap also avoids trapped moisture under the film.