A Lacetti wrapped in silver is a full color change if the film covers the painted body. Choose the finish first: gloss, satin, matte, or metallic. The fine grain of the metal flake in metallic films adds depth, while smooth finishes look painted. Silver needs clean panel lines and tight bridges on the bumpers.

Factory paint below the wrap stays protected from UV and minor scratches. Seams are placed on body edges and under panels where possible. Deep recesses like the rear hatch edge need relief cuts. The installer will clean and prep each panel before film goes down.

A removable wrap on the Lacetti peels off when the job is done well. Use hand wash and soft mitts to protect the film surface. Pressure washers can lift edges if aimed at seams. Silver shows little dirt, so the wrap stays clean longer.