An S-10 Pickup wrapped in silver starts with choosing the finish and the exact film. The color change wrap turns the factory paint into a silver surface without a respray. The cab and the bed are wrapped as two bodies, so the film is cut and applied in separate sections. Finish affects how the silver reads in direct sun and under street lights.

The factory paint on the S-10 Pickup must be clean, dry, and smooth before the silver vinyl goes on. Seams are placed along panel edges and body lines, never across a flat panel in the middle. The cab and the bed are wrapped as two bodies, so the seam between them follows the factory gap. On the third generation your S-10 Pickup runs 176.8 in (4,490 mm) long, which sets the seam placement.

A silver wrap on the S-10 Pickup is removable by a trained installer with heat and a steady pull. Hand wash with a soft sponge and pH-neutral soap; avoid automatic car washes with brushes. Do not pressure-wash film edges, mirrors, or the seam between the cab and the bed. The film can be removed without solvents when the wrap is lifted slowly.