Finishing a Cast wrapped in color shift film begins with choosing a finish group and then a specific film. Gloss, satin, matte and glitter effects each change how the color change reads on the small, upright body. Compare two or three films side by side because the same purple can look blue on one curve and green on a flat door.

The factory paint is the base for the color shift film on every Cast panel. The installer cleans the paint, checks the clear coat and then stretches the film over the wide doors and the tailgate. A seam is placed where two panels meet, never across the middle of a door, and the tailgate film ends at the edge of the rear glass.

A removable color shift film lets the Cast go back to its factory color before resale. The film lifts with controlled heat and the paint underneath stays as it was, provided the clear coat was sound before the wrap. Hand wash the car with a pH-neutral shampoo and avoid automated brushes to protect the edges of the film.