A Cast wrapped in gold starts with choosing a finish, then a film, and finally deciding between a full or partial color change. Matte films hide fingerprints and give a flat, modern look, while satin sits between matte and gloss with a soft sheen. Gloss films reflect the most light and make the gold appear deeper. On the Cast, the finish changes how the body lines and the tailgate edge catch light.
The factory paint stays protected under the film, and seams are placed where panels meet or along body lines. The Cast’s tailgate includes the rear glass, so the film ends at the edge of the glass for a clean line. Door handles, mirrors, and badges are removed for a neater install. Any stone chips or paint damage should be fixed before wrapping, because film will not hide deep marks.
A gold wrap is removable and is removed with heat, leaving the original paint underneath if the paint was in good condition. Hand wash the Cast with a soft sponge and pH-neutral soap, and avoid automatic brushes. Do not use a pressure washer close to film edges or seams, especially around the tailgate and door handles. Drying with a microfiber towel helps prevent water spots on matte and satin finishes.