A Cuore wrapped in green begins with a finish choice that sets the whole look of the color change. Matte green removes reflections and shows the panels as flat planes, while gloss green adds depth like a fresh paint coat. The film line then decides how the finish behaves during installation and in daily use. You can cover the whole car or leave the roof or pillars in the original paint.

Factory paint under a wrap only matters where it is older or already damaged, because film follows the surface it is stuck to. The Cuore keeps its paint on the tailgate around the rear glass, and the film ends at that edge. A clean panel lets the seams sit close to body lines and stay less visible. Check every panel for stone chips or deep scratches before the film goes on.

The film is removable without leaving adhesive behind when the paint was sound before install. Hand wash the wrapped car with a soft mitt and pH-neutral soap to protect the edges and finish. Avoid automatic brushes, pressure washers closer than about 50 cm, and any solvent-based cleaner. Dry the car with a microfiber towel so water does not sit at the seams.