Wraps by car

Excalibur Series IV wrap

The Excalibur Series IV wrap page covers this 1980–1985 sports car, its single generation, and the film needed for a full vinyl wrap. The Series IV is a long two-door convertible with a body length between 202.0 in (5,131 mm) and 207.0 in (5,258 mm). A complete wrap takes about 54 ft (16.5 m) of 60-inch (1.52 m) cast film, or about 69 ft (21 m) for chrome or patterned film.

1generations16.5 mof film for a full wrap

Excalibur Series IV, first generation, factory photo
Excalibur Series IV, first generation. Factory color shown.

Excalibur Series IV wrap colors and ideas

  • Series IV black wrap
  • Series IV white wrap
  • Series IV gray wrap
  • Series IV silver wrap
  • Series IV red wrap
  • Series IV blue wrap
  • Series IV green wrap
  • Series IV yellow wrap
  • Series IV orange wrap
  • Series IV purple wrap
  • Series IV pink wrap
  • Series IV teal wrap
  • Series IV brown wrap
  • Series IV gold wrap
  • Series IV chrome wrap
  • Series IV color shift wrap
  • Series IV carbon fiber wrap
  • Series IV camo and patterned wrap

How much vinyl to wrap an Excalibur Series IV

Estimates from the body dimensions in the catalog, for a 1.52 m (60 in) roll.

YearsBodyLengthFilm to order
1980–1985convertible (2 doors)202.0 in (5,131 mm) to 207.0 in (5,258 mm)about 54 ft (16.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m)

Series IV wrap cost factors

Series IV wrap cost depends on the film type, the body length, and the work required for a long convertible. The car measures between 202.0 in (5,131 mm) and 207.0 in (5,258 mm), so material use is higher than on a smaller car. A full wrap takes about 54 ft (16.5 m) of 60-inch (1.52 m) cast film, or about 69 ft (21 m) for chrome or patterned film. The installer must also work around the soft top and long panels.

  • Film for a full wrap: about 54 ft (16.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m).
  • Body: convertible (2 doors).
  • Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Series IV wraps by generation

Swipe sideways. Tap a card for the full description.

Excalibur Series IV, first generation, factory photo
Factory color shown

1980–1985 Series IV convertible (first generation)

1980–1985convertible (2 doors)202.0 in (5,131 mm) to 207.0 in (5,258 mm)

The open top of the Excalibur Series IV is left unwrapped and the film ends where the top begins. A fabric top is not covered with vinyl, so the wrap stops at the edge of the body. If the car has a folding hard top, those panels are wrapped separately as their own pieces. The area around the top opening needs careful trimming to follow the body lines.

Convertible body: a fabric top is not wrapped and the film ends where it begins; a folding hard top is wrapped as panels of its own.

Film: about 54 ft (16.5 m) of 60-inch (1.52 m) cast film; chrome or patterned film: about 69 ft (21 m).

Roof, hood, chrome delete and PPF on a Series IV

A partial wrap on the Excalibur Series IV covers the hood, mirror caps, and rear deck. Series IV chrome delete covers the window trim and badges with black film. Paint protection film (PPF) is applied as a clear film on the front end. These smaller jobs use less material than a full wrap and can be done in sections.

  • Partial wrap: hood, mirror caps, rear deck.
  • Chrome delete: window trim and badges.
  • Paint protection film: clear film for the front end, which can also go over a wrap.

Wrapping an Excalibur Series IV: body, cut-outs and film

An Excalibur Series IV vinyl wrap must follow the convertible body and its long, curved panels. The body is a two-door convertible with a length from 202.0 in (5,131 mm) to 207.0 in (5,258 mm), so installers work with large continuous surfaces. The fabric top is not wrapped, so the film ends where the top begins. Panel sizes on this car mean a full wrap uses about 54 ft (16.5 m) of 60-inch (1.52 m) cast film.

Series IV wrap ideas begin with the parts that need cut-outs or come off the car. The convertible top is left unwrapped, and the film stops at its edge. Door handles, badges, and window trim are removed for a clean install. On a folding hard top, the panels are wrapped separately as their own pieces.

For someone counting film, the Excalibur Series IV has one generation, so how much vinyl to wrap a Series IV does not change between years. The first generation spans 1980–1985 and all examples are two-door convertibles. The body length can vary from 202.0 in (5,131 mm) to 207.0 in (5,258 mm), which affects the exact amount of material. A full wrap on any Series IV takes about 54 ft (16.5 m) of 60-inch (1.52 m) cast film.

More Excalibur wraps

Questions about wrapping an Excalibur Series IV

How much vinyl does it take to wrap an Excalibur Series IV?

It takes about 54 ft (16.5 m) of 60-inch (1.52 m) cast film to wrap an Excalibur Series IV. If you choose chrome or patterned film, the amount is about 69 ft (21 m). The car is a long two-door convertible with a body length from 202.0 in (5,131 mm) to 207.0 in (5,258 mm). The fabric top is not wrapped, so the film is only for the body panels.

Is the top of a Series IV wrapped?

No, the top of a Series IV is not wrapped. The convertible top is fabric and vinyl film does not adhere to it. The film ends where the top begins. If the car has a folding hard top, those panels are wrapped separately.

Can I wrap only the hood or the roof of a Series IV?

Yes, you can wrap only the hood or the rear deck of a Series IV. A partial wrap on this car typically covers the hood, mirror caps, and rear deck. The roof is not wrapped because it is a fabric top. These jobs are smaller than a full wrap.

Is a Series IV hard to wrap?

Yes, a Series IV is harder to wrap than many cars because of its length and the convertible top. The body measures between 202.0 in (5,131 mm) and 207.0 in (5,258 mm), so installers handle long panels. The fabric top is not wrapped and the film must end neatly at its edge. A folding hard top adds extra work because its panels are wrapped separately.