A Ferrari 812 wrapped in white is a color change that reverses by removing the film later. Start by choosing the finish: matte and satin soften the body lines, super matte looks flatter, and gloss reads as a deeper wet white. Then pick your film from the groups below, because 158 options vary in texture and final look. A full wrap covers the outside paint, while a partial wrap can accent just the roof or hood.

Factory paint stays protected under a white wrap, because the film takes UV and road wear instead of the clear coat. Seams are planned along body edges and panel gaps on the 812, so they stay low-profile on its long doors and wide rear haunches. The installer uses the curves of the factory paint as the base, so any paint flaw will show through a thin film. A full wrap leaves no original color visible on the outside, except where the film ends at the fabric top.

A white wrap on the 812 is removable when the film is removed by an installer. Use hand wash only after a wrap, because pressure washers can lift film edges at the sensors and cameras. Every 812 trim has parking sensors and cameras, so the film is cut around each lens and sensor ring. That keeps the factory systems working and the wrap looking clean.