A California wrapped in orange begins with a color change that covers the factory paint completely. The finish is the first decision, because matte, satin, gloss, and metallic films all change how the orange reads on the body. The next decision is the film brand and line, since a 49 ft (15 m) roll of 60-inch (1.52 m) cast film is enough for a full wrap, while patterned film needs about 54 ft (16.5 m). After that, you decide between a full wrap or a partial job, depending on what you want covered.
Factory paint stays hidden under the wrap, but the film must be trimmed around the fog lamps on every trim of the California. On a 179.6 in (4,563 mm) to 179.9 in (4,570 mm) convertible, the seams are placed where body panels meet, so the wrap looks like paint. The folding hard top is wrapped as its own panel, with the film ending where the top begins. This leaves clean edges that are hard to see from a few steps away.
A removable wrap is taken off with heat, and the adhesive releases without pulling up clearcoat if the paint was in good shape. The first few washes should be done by hand, because a touchless wash or soft brush is safer than a high-pressure jet on the edges. On the California, the fabric top is not wrapped, so you can clean it as usual with a soft top cleaner. The wrap film itself just needs soap and water to stay clean.


