A Daytona SP3 wrapped in chrome starts with the finish you want, because chrome differs more than any other color change family. Silver chrome looks like polished metal, while black chrome is deeper and red chrome is far more aggressive on this car. Pick the finish first, then compare films inside that finish. The rear deck of this targa has long flat surfaces that reward a chrome film with careful, low-stretch installation.

Factory paint condition decides the result on a Daytona SP3 chrome wrap because chrome shows a flaw under the film. Clean the paint properly and remove all wax before the film goes on, since chrome film does not hide a poor surface. Seams are part of a full wrap on this 184.5 in (4,686 mm) body. A good installer will place them on body lines so they disappear from view.

A chrome wrap on the Daytona SP3 is removable when it is a quality cast film installed on healthy factory paint. The film is removed with controlled heat and it leaves no adhesive behind in normal cases. Hand wash the car with a soft mitt and mild soap after the wrap is installed. Avoid pressure washers and brushes that may lift the film edge.