Wrapping a Fiesta ST in color shift film starts with the finish, then the film line, and finally the choice of a full or partial color change. On the subcompact hatchback the color shift is most visible across the side doors and the roof, because a single panel shows the shift within one piece of film. For a full wrap the door jambs stay in the factory paint unless you ask for them to be wrapped. A partial wrap can put the shifting color only on the roof and hood.
The Fiesta ST factory paint is the base for the film, so its condition sets how the color shift lies and where seams can be hidden. Every generation of this car has a tailgate with the rear glass in it, so the film ends at the edge of the glass and no seam crosses the glass. On the sixth generation every trim has parking sensors in the bumpers, and the film is cut around each sensor. A clean, wax-free panel is what makes the color shift lay down without silvering.
A color shift wrap on the Fiesta ST is removable, and the film comes off with heat and a steady pull that leaves the factory paint untouched. After the wrap is on, hand washing is the safe way to keep the color shift clean without lifting an edge. A pressure washer is fine at a distance, but a brush can scratch the chameleon film. The wrap does not need a special coating, so your hand wash routine can stay the same.

