Deciding on a Puma wrapped in carbon fiber film starts with the finish, because both weaves and forged patterns come in gloss, satin, and matte. Then pick the film itself, since each brand has a slightly different repeat size and depth in its weave. The last choice is color change scope: the full body, or only selected panels like a hood and mirrors. On the Puma the full wrap is the only way to make the weave run uninterrupted over the whole body.
The Ford Puma suits a carbon fiber wrap well, because the factory paint on every trim is two-tone with a contrasting roof. The wrap can keep that split by leaving the factory roof color visible, or cover it with one full-body film design. Put the seams where the eye does not look, so the weave lines run straight across each panel. The film is cut around the parking sensors in the bumpers on every Puma.
A carbon fiber wrap on the Puma is removable, which means it protects the factory paint underneath when it is removed by hand. The film is cast, so it follows the curves of the car without lifting at the edges. Look after it with a hand wash, because a pressure washer too close can force water under the film. This keeps the finish clean without adding swirl marks to the vinyl.
