A Borui GE wrapped in red starts with choosing the finish that fits how you want the color to read on this body. Matte red keeps the sedan tight and low-key, while gloss gives the large panels a deep wet look. The wrap is a color change product that can cover the factory paint without changing it permanently. Every finish group on this page gives you real films to compare before you decide.
The factory paint under the wrap stays clean when the film is installed on a car with no paint damage. Seams are part of a wrap, and on the Borui GE they can be tucked close to roof rails, door edges and the trunk opening. The installer should show you where the seams will sit before the job starts. A good seam follows a body line and stays out of direct view when you walk around the car.
The vinyl is removable, so the red can be taken off the Borui GE later without leaving adhesive on the clear coat. Hand wash the wrapped car with a soft mitt and avoid automatic brushes that can lift an edge. The charge port area on plug-in and electric versions is wrapped as a small separate piece, so it can be opened and closed without pulling the film.